This page will capture additional notes that will perhaps help you in using the multi-node non-HA bare-metal JOID install for Academy.

===== Restarting the nodes =====

You should be able to power-down the NUC boxes and move them to another place. The should power-up and be reconnected using the same addresses they were assigned in the install (at least this works for the 3-node deploy). The procedure to power-up is:
  * power-on the jumphost
  * Wait for the MAAS UI to be restored at http://192.168.10.3/MAAS
  * Via the MAAS Nodes panel (http://192.168.10.3/MAAS/#/nodes), select bootstrap.maas and "Take Action" "Power on"
  * Wait for the JuJu UI to be restored at https://192.168.10.20/login/
  * Via the MAAS Nodes panel, power on the controller node
  * On the jumphost, repeatedly enter the command until you see only "compute1.maas" listed in the output
<code>
sudo juju status --format=tabular | grep lost
</code>
  * Via the MAAS Nodes panel, power on the compute node
  * Verify the Horizon UI is active at http://192.168.10.114/admin/ (or the address that applies for your install)
  * Verify the DLUX UI is active at http://192.168.10.113:8181/dlux/index.html (or the address that applies for your install)
  * SSH into the jumphost (root/Op3nStack) and restart the Foreman VM