Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

This page will capture additional notes that will perhaps help you in using the multi-node non-HA bare-metal JOID install for Academy.

===== Restarting the nodes =====

You should be able to power-down the NUC boxes and move them to another place. The should power-up and be reconnected using the same addresses they were assigned in the install (at least this works for the 3-node deploy). The procedure to power-up is:
  * power-on the jumphost
  * Wait for the MAAS UI to be restored at http://192.168.10.3/MAAS
  * Via the MAAS Nodes panel (http://192.168.10.3/MAAS/#/nodes), select bootstrap.maas and "Take Action" "Power on"
  * Wait for the JuJu UI to be restored at https://192.168.10.20/login/
  * Via the MAAS Nodes panel, power on the controller node
  * On the jumphost, repeatedly enter the command until you see only "compute1.maas" listed in the output
<code>
sudo juju status --format=tabular | grep lost
</code>
  * Via the MAAS Nodes panel, power on the compute node
  * Verify the Horizon UI is active at http://192.168.10.114/admin/ (or the address that applies for your install)
  * Verify the DLUX UI is active at http://192.168.10.113:8181/dlux/index.html (or the address that applies for your install)
  * SSH into the jumphost (root/Op3nStack) and restart the Foreman VM

Wiki

User Tools

Site Tools

Page Tools