khaleesi_guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
khaleesi_guide [2015/04/07 21:58] Daniel Farrell [Checking Tempest Results] Marked a code block as XML for syntax highlighting |
khaleesi_guide [2015/04/07 22:23] (current) Daniel Farrell [Running Khaleesi] Proper code formatting for Khaleesi run cmd |
||
|---|---|---|---|
| Line 16: | Line 16: | ||
| <code> | <code> | ||
| sudo rpm -i http://dl.fedoraproject.org/pub/epel/7/x86_64/e/epel-release-7-5.noarch.rpm | sudo rpm -i http://dl.fedoraproject.org/pub/epel/7/x86_64/e/epel-release-7-5.noarch.rpm | ||
| - | sudo yum -y install python-pip python-virtualenv gcc git | + | sudo yum -y install python-pip python-virtualenv gcc git \ |
| - | sudo yum -y install python-keystoneclient python-novaclient python-glanceclient python-neutronclient python-keystoneclient | + | python-keystoneclient python-novaclient \ |
| - | sudo yum -y install sshpass | + | python-glanceclient python-neutronclient \ |
| + | python-keystoneclient sshpass | ||
| </code> | </code> | ||
| Line 28: | Line 29: | ||
| <code> | <code> | ||
| - | virtualenv venv | + | virtualenv khaleesi_venv |
| - | source venv/bin/activate | + | source khaleesi_venv/bin/activate |
| pip install ansible | pip install ansible | ||
| - | cd khaleesi | + | cd khaleesi/tools/ksgen |
| - | cd tools/ksgen | + | |
| python setup.py develop | python setup.py develop | ||
| cd ../.. | cd ../.. | ||
| </code> | </code> | ||
| - | From the above you can see that "source venv/bin/activate" will activate your virtual environment. Simply use deactivate to exit. Now we need to create a default Ansible config: | + | From the above you can see that ''source khaleesi_venv/bin/activate'' will activate your virtual environment. Simply use deactivate to exit. Now we need to create a default Ansible config: |
| <code> | <code> | ||
| Line 130: | Line 130: | ||
| Now that you have Khaleesi installed and a configuration file, you are ready to rebuild your nodes. To run simply execute the following inside of your Khaleesi directory: | Now that you have Khaleesi installed and a configuration file, you are ready to rebuild your nodes. To run simply execute the following inside of your Khaleesi directory: | ||
| + | <code> | ||
| ./run.sh --use ../ksgen_settings.yml playbooks/quickstack.yml --no-logs -vv | ./run.sh --use ../ksgen_settings.yml playbooks/quickstack.yml --no-logs -vv | ||
| + | </code> | ||
| The sequence of execution is as follows: | The sequence of execution is as follows: | ||
khaleesi_guide.1428443900.txt.gz · Last modified: 2015/04/07 21:58 by Daniel Farrell
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution 4.0 International License
