vm2vm_mst
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
vm2vm_mst [2015/09/03 04:30] Jun Nakajima |
vm2vm_mst [2015/09/03 04:31] Jun Nakajima |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| How is this mechanism used for inter-VM communication? It should be straightforward. Take a look at a simple example where VM1 receives data from VM2. For example, DPDK runs in VM2, forwarding packets to VM1. | How is this mechanism used for inter-VM communication? It should be straightforward. Take a look at a simple example where VM1 receives data from VM2. For example, DPDK runs in VM2, forwarding packets to VM1. | ||
| - | In VM1 the device driver uses polling to keep DMA operations of **R** open, looking at the "**bus address**" (the step number should match with the one in the figure): | + | In VM1 the device driver uses polling to keep DMA operations of **R** open, looking at the "**bus address**" (the step numbers below should match with the one in the figure): |
| - For performance reasons, the buffer addresses would be static or covered by larger regions that are mapped by virtual IOMMU. The mapping is determined and established by VM1. | - For performance reasons, the buffer addresses would be static or covered by larger regions that are mapped by virtual IOMMU. The mapping is determined and established by VM1. | ||
| - QEMU of VM1 communicates the configuration of virtual IOMMU to QEMU of VM2. This would require extensions to the vhost-user protocol. | - QEMU of VM1 communicates the configuration of virtual IOMMU to QEMU of VM2. This would require extensions to the vhost-user protocol. | ||
vm2vm_mst.txt ยท Last modified: 2015/09/03 04:33 by Jun Nakajima
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution 4.0 International License
