copper:academy
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
copper:academy [2015/12/08 06:34] Bryan Sullivan |
copper:academy [2016/03/02 01:00] (current) Bryan Sullivan |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| * the mechanisms supported by the additional components for configuration policy management | * the mechanisms supported by the additional components for configuration policy management | ||
| * use cases, demos, and techniques supporting the Copper scope | * use cases, demos, and techniques supporting the Copper scope | ||
| + | |||
| + | === Multi-Node Apex-based install on 3 bare metal nodes (non-HA) === | ||
| + | |||
| + | This is a work in progress. The target system is as described for JOID below. | ||
| + | |||
| + | See [[https://wiki.opnfv.org/copper/academy/apex|Apex install procedure]] for the basic install. | ||
| === Multi-Node JOID-based install on 3 bare metal nodes (non-HA) === | === Multi-Node JOID-based install on 3 bare metal nodes (non-HA) === | ||
| - | See [[https://wiki.opnfv.org/copper/academy/joid|Joid install procedure]] for the basic install. | + | As shown in the diagram below, an internet connection is assumed to be available. In some cases (e.g. hackfests etc) you may need to connect thru a wifi network. Because it may not be obvious how to do this with a fixed configuration, see [[https://wiki.opnfv.org/copper/academy/wifi|getting your POD connected to the internet via wifi]]. |
| + | |||
| + | See [[https://wiki.opnfv.org/copper/academy/joid|Joid install procedure]] for the basic install, and [[https://wiki.opnfv.org/copper/academy/joid/notes|additional notes]]. | ||
| See [[https://wiki.opnfv.org/copper/academy/joid/congress|Congress install procedure]] for installation of OpenStack Congress in an LXC container on the JOID-based controller node. | See [[https://wiki.opnfv.org/copper/academy/joid/congress|Congress install procedure]] for installation of OpenStack Congress in an LXC container on the JOID-based controller node. | ||
| + | |||
| + | See [[https://wiki.opnfv.org/copper/academy/congress/test|Congress test procedures]] for notes on testing Congress. | ||
| The hardware used in this includes: | The hardware used in this includes: | ||
copper/academy.1449556489.txt.gz · Last modified: 2015/12/08 06:34 by Bryan Sullivan
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution 4.0 International License
